CTXSW(9) BSD Kernel Manual CTXSW(9)
mi_switch, cpu_switch - switch to another process context
#include <sys/param.h> #include <sys/proc.h> void mi_switch(void); void cpu_switch(void);
The mi_switch() function implements the machine-independent prelude to a process context switch. It is called from only a few distinguished places in the kernel code as a result of the principle of non-preemptable kernel mode execution. The three major uses of mi_switch() can be enumerated as follows: 1. From within sleep(9) and tsleep(9) when the current process voluntarily relinquishes the CPU to wait for some resource to become available. 2. After handling a trap (e.g., a system call or device interrupt) when the kernel prepares a return to user-mode exe- cution. This case is typically handled by machine-dependent trap-handling code after detection of a change in the signal disposition of the current process, or when a higher priority process might be available to run. The latter event is commun- icated by the machine-independent scheduling routines by cal- ling the machine-dependent need_resched(void). 3. In the signal handling code (see issignal(9)) if a signal is delivered that causes a process to stop. mi_switch() records the amount of time the current process has been run- ning in the process structure and checks this value against the CPU time limits allocated to the process (see getrlimit(2)). Exceeding the soft limit results in a SIGXCPU signal to be posted to the process, while exceeding the hard limit will cause a SIGKILL. For a process which accu- mulated longer than 10 minutes of CPU time, its nice level is raised to 4. After these administrative tasks are done, mi_switch() hands over con- trol to the machine dependent routine cpu_switch(void), which will per- form the actual process context switch. cpu_switch() will make a choice amongst the processes which are ready to run from a priority queue data-structure. The priority queue consists of an array qs[NQS] of queue header structures each of which identifies a list of runnable processes of equal priority (see <sys/proc.h>). A single word whichqs containing a bit mask identifying non-empty queues assists in selecting a process quickly. cpu_switch() must remove the first pro- cess from the list on the queue with the highest priority (lower indices in qs indicate higher priority), and assign the address of its process structure to the global variable curproc. If no processes are available on the run queues, cpu_switch() shall go into an "idle" loop. The idle loop must allow interrupts to be taken that will eventually cause processes to appear again on the run queues. The variable curproc should be NULL while cpu_switch() waits for this to happen. Note that mi_switch() and thus cpu_switch() should be called at splhigh(9).
spl(9), tsleep(9), wakeup(9) MirOS BSD #10-current November 24, 1996 1
Generated on 2015-04-13 10:26:13 by $MirOS: src/scripts/roff2htm,v 1.80 2015/01/02 13:54:19 tg Exp $
These manual pages and other documentation are copyrighted by their respective writers;
their source is available at our CVSweb,
AnonCVS, and other mirrors. The rest is Copyright © 2002–2015 The MirOS Project, Germany.
This product includes material provided by Thorsten Glaser.
This manual page’s HTML representation is supposed to be valid XHTML/1.1; if not, please send a bug report – diffs preferred.