PLOT(5) UNIX Programmer's Manual PLOT(5)
plot - graphics interface
Files of this format are produced by routines described in plot(3X) and plot(3F), and are interpreted for various dev- ices by commands described in plot(1G). A graphics file is a stream of plotting instructions. Each instruction consists of an ASCII letter usually followed by bytes of binary information. The instructions are executed in order. A point is designated by four bytes representing the x and y values; each value is a signed integer. The last designated point in an l, m, n, a, or p instruction becomes the `current point' for the next instruction. The a and c instructions change the current point in a manner dependent upon the specific device. Each of the following descriptions begins with the name of the corresponding routine in plot(3X). m move: The next four bytes give a new current point. n cont: Draw a line from the current point to the point given by the next four bytes. p point: Plot the point given by the next four bytes. l line: Draw a line from the point given by the next four bytes to the point given by the following four bytes. t label: Place the following ASCII string so that its first character falls on the current point. The string is ter- minated by a newline. a arc: The first four bytes give the center, the next four give the starting point, and the last four give the end point of a circular arc. The least significant coordinate of the end point is used only to determine the quadrant. The arc is drawn counter-clockwise. c circle: The first four bytes give the center of the cir- cle, the next two the radius. e erase: Start another frame of output. f linemod: Take the following string, up to a newline, as the style for drawing further lines. The styles are `dot- ted,' `solid,' `longdashed,' `shortdashed,' and `dot- dashed.' Effective only in plot 4014 and plot ver. s space: The next four bytes give the lower left corner of the plotting area; the following four give the upper MirOS BSD #10-current April 29, 1991 1 PLOT(5) UNIX Programmer's Manual PLOT(5) right corner. The plot will be magnified or reduced to fit the device as closely as possible. Space settings that exactly fill the plotting area with unity scaling appear below for devices supported by the filters of plot(1G). The upper limit is just outside the plotting area. In every case the plotting area is taken to be square; points outside may be displayable on dev- ices whose face isn't square. 4013 space(0, 0, 780, 780); 4014 space(0, 0, 3120, 3120); ver space(0, 0, 2048, 2048); 300, 300s space(0, 0, 4096, 4096); 450 space(0, 0, 4096, 4096);
plot(1G), plot(3X), plot(3F), graph(1G)
A label instruction immediately followed by a cont instruc- tion does the wrong thing on a 4014. MirOS BSD #10-current April 29, 1991 2
Generated on 2015-10-06 19:36:22 by $MirOS: src/scripts/roff2htm,v 1.80 2015/01/02 13:54:19 tg Exp $
These manual pages and other documentation are copyrighted by their respective writers;
their source is available at our CVSweb,
AnonCVS, and other mirrors. The rest is Copyright © 2002–2015 The MirOS Project, Germany.
This product includes material provided by Thorsten Glaser.
This manual page’s HTML representation is supposed to be valid XHTML/1.1; if not, please send a bug report – diffs preferred.